Neighbor Override-Capability - Allied Telesis AR2050V Command Reference Manual

BGP BGP4+ C
AND OMMANDS
-
NEIGHBOR OVERRIDE CAPABILITY

neighbor override-capability

Overview Use this command to override a capability negotiation result for BGP and BGP4+.
Use the no variant of with this command to disable this function.
Syntax neighbor <neighborid> override-capability
no neighbor <neighborid> override-capability
Mode Router Configuration
awplus#
Examples [BGP]
awplus(config)#
awplus(config-router)#
awplus#
awplus(config)#
awplus(config-router)#
override-capability
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router)#
awplus(config-router)#
awplus(config-router)#
awplus#
awplus(config)#
awplus(config-router)#
C613-50186-01 Rev B
Parameter Description
<neighborid> {<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address>
<ipv6-addr>
<peer-group>
configure terminal
router bgp 10
configure terminal
router bgp 10
configure terminal
router bgp 10
configure terminal
router bgp 10
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Specify the address of an IPv4 BGP neighbor,
in dotted decimal notation A.B.C.D.
Specify the address of an IPv6 BGP4+
neighbor, entered in hexadecimal in the
format X:X::X:X.
Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) command, and
route-map command. When this parameter is
used with this command, the command
applies on all peers in the specified group.
neighbor 10.10.0.72 override-capability
no neighbor 10.10.0.72
neighbor group1 peer-group
neighbor 10.10.10.72 remote-as 10
neighbor 10.10.10.72 peer-group group1
neighbor group1 override-capability
no neighbor group1 override-capability
neighbor
1247