Neighbor Dont-Capability-Negotiate - Allied Telesis AR2050V Command Reference Manual

BGP BGP4+ C
AND OMMANDS
- -
NEIGHBOR DONT CAPABILITY NEGOTIATE

neighbor dont-capability-negotiate

Overview Use this command to disable capability negotiation for BGP and BGP4+.
The capability negotiation is performed by default. This command is used to allow
compatibility with older BGP versions that have no capability parameters used in
open messages between peers.
Use the no variant of this command to enable capability negotiation.
neighbor <neighborid> dont-capability-negotiate
Syntax
no neighbor <neighborid> dont-capability-negotiate
Mode Router Configuration
C613-50186-01 Rev B
Parameter Description
<neighborid> {<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address>
<ipv6-addr>
<peer-group>
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Specify the IPv4 address of the BGP neighbor
in dotted decimal, in the format A.B.C.D.
Specify the IPv6 address of the BGP4+
neighbor, entered in hexadecimal in the
format X:X::X:X.
Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) and neighbor route-map
commands. When this parameter is used with
this command, the command applies on all
peers in the specified group.
1226