Ip Domain-Lookup - Allied Telesis AR2050V Command Reference Manual

D N S (DNS) C
OMAIN AME ERVICE
-
IP DOMAIN LOOKUP

ip domain-lookup

Overview This command enables the DNS client on your device. This allows you to use
domain names instead of IP addresses in commands. The DNS client resolves the
domain name into an IP address by sending a DNS inquiry to a DNS server,
specified with the
The no variant of this command disables the DNS client. The client will not attempt
to resolve domain names. You must use IP addresses to specify hosts in
commands.
ip domain-lookup
Syntax
no ip domain-lookup
Mode Global Configuration
Usage The client is enabled by default. However, it does not attempt DNS inquiries unless
there is a DNS server configured.
If you are using DNS Relay (see the command
domain lookup enabled.
Examples To enable the DNS client on your device, use the following commands:
awplus#
awplus(config)#
To disable the DNS client on your device, use the following commands:
awplus#
awplus(config)#
Related ip domain-list
Commands
ip domain-name
ip name-server
show hosts
show ip name-server
C613-50186-01 Rev B
OMMANDS
ip name-server
configure terminal
ip domain-lookup
configure terminal
no ip domain-lookup
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
command.
ip dns forwarding), you must have IP
721