Ppp Timeout Idle - Allied Telesis AR2050V Command Reference Manual

PPP C
OMMANDS

PPP TIMEOUT IDLE

ppp timeout idle
Overview Use this command to specify an idle time when a PPP connection is disconnected.
Use the no variant of this command to reset the idle time to the default of 60
seconds.
Syntax ppp timeout idle <0-99999>
no ppp timeout idle
Default PPP timeout idle is not set and the PPP Dial on Demand feature is disabled. If no
idle time is set, the default value of 60 seconds is used.
Mode Interface Configuration
Usage This command allows an idle timer to disconnect a PPP connection after a
specified time. The timer is reset upon either ingress or regress user traffic.
Non-user traffic such as Link Control Protocol (LCP) keepalives and Network
Control Protocol (NCP) negotiation packets do not reset the idle timer.
Examples To set the idle time to 30 seconds, enter the below commands:
awplus#
awplus(config)#
awplus(config-if)#
30
To disable the use of the timer and disable the PPP Dial on Demand feature, enter
the below commands:
awplus#
awplus(config)#
awplus(config-if)#
idle 30
Validation show running-config interface
Commands
C613-50186-01 Rev B
Parameter Description
<0-99999>
The time in seconds before the idle timeout disconnects. If this is
not specified the default value of 60 seconds is used.
configure terminal
interface ppp0
configure terminal
interface ppp0
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ppp timeout idle
no ppp timeout
611