Set Atomic-Aggregate - Allied Telesis AR2050V Command Reference Manual

R M C
OUTE AP OMMANDS
-
SET ATOMIC AGGREGATE

set atomic-aggregate

Overview Use this command to add an atomic aggregate set clause to a route map entry.
When a BGP update message matches the route map entry, the device adds the
atomic aggregate attribute to the update.
Use the no variant of this command to remove the set clause.
set atomic-aggregate
Syntax
no set atomic-aggregate
Mode Route-map Configuration
Usage This command is valid for BGP update messages only.
To use entry 3 of the route map called rmap1 to add the atomic aggregator
Example
attribute to matching update messages, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
Related route-map
Commands
show route-map
C613-50186-01 Rev B
configure terminal
route-map rmap1 permit 3
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
set atomic-aggregate
1402