Neighbor Version (Bgp Only) - Allied Telesis AR2050V Command Reference Manual

BGP BGP4+ C
AND OMMANDS
(BGP )
NEIGHBOR VERSION ONLY

neighbor version (BGP only)

Overview Use this command to configure the device to accept only a particular BGP version.
Use the no variant of this command to use the default BGP version (version 4).
Syntax neighbor <neighborid> version <version>
no neighbor <neighborid> version
Mode Router Configuration or IPv4 Address Family Configuration
Usage By default, the system uses BGP version 4 and on request dynamically negotiates
down to version 2. Using this command disables the router's version-negotiation
capability and forces the router to use only a specified version with the neighbor.
C613-50186-01 Rev B
Parameter Description
<neighborid> {<ip-address>|<peer-group>}
<ip-address> The address of an IPv4 BGP neighbor, in dotted
<peer-group> Enter the name of an existing peer-group. For
<version>
{4} Specifies the BGP version number.
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
decimal notation A.B.C.D.
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) command, and
command. When this parameter is used with
this command, the command applies on all
peers in the specified group.
neighbor route-map
1298