Ip Igmp Last-Member-Query-Interval - Allied Telesis AR2050V Command Reference Manual

IGMP IGMP S C
AND NOOPING OMMANDS
- - -
IP IGMP LAST MEMBER QUERY INTERVAL

ip igmp last-member-query-interval

Overview Use this command to configure the frequency at which the router sends IGMP
group specific host query messages.
Use the no variant of this command to set this frequency to the default.
Syntax ip igmp last-member-query-interval <interval>
no ip igmp last-member-query-interval
Default 1000 milliseconds
Mode Interface Configuration for a VLAN or Eth interface.
Usage This command applies to Eth interfaces configured for IGMP and VLAN interfaces
configured for IGMP or IGMP Snooping.
Example To change the IGMP group-specific host query message interval to 2 seconds
(2000 milliseconds) on vlan2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ip igmp last-member-query-count
Commands
show ip igmp interface
show running-config
C613-50186-01 Rev B
Parameter Description
<interval>
The frequency in milliseconds at which IGMP group-specific host
query messages are sent, in the range 1000-25500.
configure terminal
interface vlan2
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ip igmp last-member-query-interval 2000
1555