PPP
E
(PPP
E) C
OVER
THERNET
O
-
-
SHOW PPPOE
AC CONFIG
CHECK
show pppoe-ac config-check
Overview
Use this command to display information about the validity of the configurations
for PPPoE AC routes.
show pppoe-ac [<label>] config-check
Syntax
Mode
Privileged Exec
Example
To display the validity of the configurations for all PPPoE AC services, use the
command:
awplus#
To display the validity of the configurations for the PPPoE AC labelled "ac1" only,
use the command:
awplus#
Output
Figure 20-2: Example output from show pppoe-ac config-check
Table 20-1: Parameters in the output from show pppoe-ac config-check
C613-50186-01 Rev B
OMMANDS
Parameter
Description
<label>
The label for the PPPoE AC service.
show pppoe-ac config-check
show pppoe-ac ac1 config-check
awplus#sh pppoe-ac config-check
PPPoE Access Concentrator ac:
Incomplete Configuration
Required: add pppoe-ac-service to one or more interfaces
Required: destination
Required: service-name
Required: l2tp peer-address
Required: l2tp profile
PPPoE Access Concentrator ac1:
Incomplete Configuration
Required: add pppoe-ac-service to one or more interfaces
PPPoE Access Concentrator pppoeservice:
Complete Configuration
Parameter
Incomplete
configuration
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Further configuration is required to create a valid PPPoE
AC service.
637