Ppp-Auth-Protocol - Allied Telesis AR2050V Command Reference Manual

PPP E (PPP E) C
OVER THERNET O
- -
PPP AUTH PROTOCOL

ppp-auth-protocol

Overview Use this command to set the authentication protocol to be used for this PPPoE
Access Concentrator (AC) service.
Use the no variant of this command to reset the authentication protocol to the
default.
Syntax ppp-auth-protocol {chap|pap|eap}
no ppp-auth-protocol
Default Default PPP authentication protocol is CHAP.
Mode PPPoE Access Concentrator Configuration
Example To set PPP authentication for the PPPoE AC service 'ISP-service' to use PAP, use the
commands:
awplus#
awplus(config)#
awplus(config-pppoe-ac)#
To set PPP authentication to use the default (CHAP), use the commands:
awplus#
awplus(config)#
awplus(config-pppoe-ac)#
Related destination l2tp
Commands
l2tp peer-address dns-lookup
l2tp peer-address radius-lookup group
l2tp peer-address static
l2tp profile
pppoe-ac
service-name
show running-config pppoe-ac
C613-50186-01 Rev B
OMMANDS
Parameter Description
chap
Set the PPP authentication protocol to Challenge Handshake
Authentication Protocol (default).
pap
Set the PPP authentication protocol to Password Authentication
Protocol.
eap
Set the PPP authentication protocol to Extensible Authentication
Protocol.
configure terminal
pppoe-ac ISP-service
configure terminal
pppoe-ac ISP-service
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ppp-auth-protocol pap
no ppp-auth-protocol
630