Ipv6 Nd Current-Hoplimit - Allied Telesis AR2050V Command Reference Manual

IP 6 C
V OMMANDS
6 -
IPV ND CURRENT HOPLIMIT

ipv6 nd current-hoplimit

Overview Use this command to specify the advertised current hop limit used between IPv6
Routers.
Use the no variant of this command to reset the current advertised hop limit to its
default "0".
Syntax ipv6 nd current-hoplimit <hoplimit>
no ipv6 nd current-hoplimit
Default 0 (No advertised current hop limit specified)
Mode Interface Configuration for a VLAN interface or a PPP interface.
Examples To set the advertised current hop limit to "2" between IPv6 Routers on the VLAN
interface "vlan2", use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To reset the advertised current hop limit to the default "0" on the VLAN interface
"vlan2", use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the advertised current hop limit to "2" between IPv6 Routers on the PPP
interface "ppp0", use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To reset the advertised current hop limit to the default "0" on the PPP interface
"ppp0", use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50186-01 Rev B
Parameter Description
<hoplimit>
Specifies the advertised current hop limit value.
Valid values are from 0 to 255 hops.
configure terminal
interface vlan2
configure terminal
interface vlan2
configure terminal
interface ppp0
configure terminal
interface ppp0
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ipv6 nd current-hoplimit 2
no ipv6 nd current-hoplimit
ipv6 nd current-hoplimit 2
no ipv6 nd current-hoplimit
765