Ipv6 Eui64-Linklocal - Allied Telesis AR2050V Command Reference Manual

IP 6 C
V OMMANDS
6 64-
IPV EUI LINKLOCAL

ipv6 eui64-linklocal

Overview When IPv6 is enabled on an interface, an EUI link-local address is generated and
installed on the interface. In other words, ipv6 eui64-linklocal is enabled by
default on any IPv6 enabled interface.
Use the no variant of this command to disallow the automatic generation of the
EUI-64 link-local address on an IPv6 enabled interface.
ipv6 eui64-linklocal
Syntax
no ipv6 eui64-linklocal
Default The command ipv6 eui64-linklocal is enabled by default on any IPv6 enabled
interface.
Mode Interface
Example To enable IPv6 on an interface eth1, and use the link-local address of fe80 : :1/10
instead of the EUI-64 link-local that is automatically generated, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 address
Commands
ipv6 address autoconfig
ipv6 enable
Command Version 5.4.7-0.1: command added
changes
C613-50186-01 Rev B
configure terminal
interface eth1
ipv6 enable
no ipv6 eui64-linklocal
ipv6 address fe80::1/10
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
761