Neighbor Default-Originate - Allied Telesis AR2050V Command Reference Manual

BGP BGP4+ C
AND OMMANDS
-
NEIGHBOR DEFAULT ORIGINATE

neighbor default-originate

Overview Use this command to allow a BGP or BGP4+ local router to send the default route
to a neighbor.
Use the no variant of this command to send no route as a default route.
Syntax neighbor {<neighborid>} default-originate [route-map
<routemap-name>]
no neighbor {<neighborid>} default-originate [route-map
<routemap-name>]
Mode [BGP] Router Configuration or IPv4 Address Family Configuration
Mode [BGP4+] IPv6 Address Family Configuration
C613-50186-01 Rev B
Parameter Description
<neighborid> {<ip-address>|<ipv6-addr>|<peer-group>}
<ip-
address>
<ipv6-addr>
<peer-
group>
route-map
If a route-map is specified, then the route table must contain at
least one route that matches the permit criteria of the route
map before the default route will be advertised to the specified
neighbor.
<routemap-name>
Enter the route-map name.
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Specify the address of an IPv4 BGP neighbor,
in dotted decimal notation A.B.C.D.
Specify the address of an IPv6 BGP4+
neighbor, entered in hexadecimal in the
format X:X::X:X.
Enter the name of an existing peer-group.
For information on how to create peer
groups, refer to the neighbor peer-group
(add a neighbor) command, and
route-map command. When this parameter
is used with this command, the command
applies on all peers in the specified group.
neighbor
1218