Set Weight - Allied Telesis AR2050V Command Reference Manual

R M C
OUTE AP OMMANDS

SET WEIGHT

set weight
Overview Use this command to add a weight set clause to a route map entry.
The weight value assists in best path selection of BGP routes. It is stored with the
route in the BGP routing table, but is not advertised to peers. When there are
multiple routes with a common destination, the device uses the route with the
highest weight value.
When a route matches the route map entry, the device sets its weight to the
specified value.
Use the no variant of this command to remove the set clause.
Syntax set weight <weight>
no set weight [<weight>]
Mode Route-map Configuration
Usage This command is valid for BGP routes only.
To use entry 3 of the route map called rmap1 to give matching routes a weight of
Example
60, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
Related route-map
Commands
show route-map
C613-50186-01 Rev B
Parameter Description
<weight>
<0-4294967295>
The weight value.
configure terminal
route-map rmap1 permit 3
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
set weight 60
1419