Network Synchronization - Allied Telesis AR2050V Command Reference Manual

BGP BGP4+ C
AND OMMANDS

NETWORK SYNCHRONIZATION

network synchronization
Overview Use this command to ensure the exact same static network prefix, specified
through any of the network commands, is local or has IGP reachability before
introduction to BGP or BGP4+.
Use the no variant of this command to disable this function.
Syntax network synchronization
no network synchronization
Default Network synchronization is disabled by default.
Mode [BGP] Router Configuration and IPv4 Address Family [ipv4 unicast] Configuration
Mode [BGP4+] IPv6 Address Family [ipv6 unicast] Configuration
Examples [BGP] The following example enables IGP synchronization of BGP static network routes
in the Router Configuration mode.
awplus#
awplus(config)#
awplus(config-router)#
The following example enables IGP synchronization of BGP static network routes
in the IPv4-Unicast address family.
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router-af)#
Example [BGP4+] The following example enables IGP synchronization of BGP4+ static network
routes in the IPv6-Unicast address family.
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router-af)#
C613-50186-01 Rev B
configure terminal
router bgp 11
network synchronization
configure terminal
router bgp 11
address-family ipv4 unicast
configure terminal
router bgp 11
address-family ipv6 unicast
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
network synchronization
network synchronization
1306