Use-Ipv4-For-Ipv6-Updates (Ddns) - Allied Telesis AR2050V Command Reference Manual

D N S (DNS) C
OMAIN AME ERVICE
- 4- - 6- (DDNS)
USE IPV FOR IPV UPDATES

use-ipv4-for-ipv6-updates (DDNS)

Overview Use this command to send IPv6 updates using IPv4.
Use the no variant of this command to stop sending IPv6 updates using IPv4.
Syntax use-ipv4-for-ipv6-updates
no use-ipv4-for-ipv6-updates
Default Disabled
Mode DDNS Update Method Configuration
Usage If your DDNS provider supports IPv6 but does not support sending updates in IPv6
then this command is used so IPv6 updates can be sent using IPv4 instead. The
suppress-ipv4-updates command is used in conjunction with this command to
suppress IPv4 updates and send only IPv6 updates instead.
example To send IPv6 updates using IPv4 for the method "dyndns" and to suppress IPv4
updates, use the commands:
awplus#
awplus(config)#
awplus(config-ddns-update-method)#
awplus(config-ddns-update-method)#
Related ddns-update-method
Commands
suppress-ipv4-updates (DDNS)
Command Version 5.4.7-0.1: command added
changes
C613-50186-01 Rev B
OMMANDS
configure terminal
ddns-update-method dyndns
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
use-ipv4-for-ipv6-updates
suppress-ipv4-updates
750