Set Aggregator - Allied Telesis AR2050V Command Reference Manual

R M C
OUTE AP OMMANDS

SET AGGREGATOR

set aggregator
Overview Use this command to add an aggregator set clause to a route map entry.
When a BGP update message matches the route map entry, the device sets the
update's aggregator attribute. The aggregator attribute specifies the AS and IP
address of the device that performed the aggregation.
Use the no variant of this command to remove the set clause.
set aggregator as <asnum> <ip-address>
Syntax
no set aggregator as
Mode Route-map Configuration
Usage An Autonomous System (AS) is a collection of networks under a common
administration sharing a common routing strategy. It is subdivided by areas, and is
assigned a unique 16- bit number. Use the set aggregator command to assign an
AS number for the aggregator.
This command is valid for BGP update messages only.
To use entry 3 of the route map called myroute to set the aggregator attribute to
Example
4310.10.0.3 in matching update messages, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
To remove all aggregator attributes for entry 3 of the route map called myroute,
use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
Related route-map
Commands
show route-map
C613-50186-01 Rev B
Parameter Description
<asnum>
The AS number of the aggregator.
<ip-address>
The IP address of the aggregator.
configure terminal
route-map myroute permit 3
configure terminal
route-map myroute permit 3
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
set aggregator as 43 10.10.0.3
no set aggregator as
1400