Distance (Ospf) - Allied Telesis AR2050V Command Reference Manual

OSPF C
OMMANDS
(OSPF)
DISTANCE

distance (OSPF)

Overview This command sets the administrative distance for OSPF routes based on the route
type. Your device uses this value to select between two or more routes to the same
destination from two different routing protocols. The route with the smallest
administrative distance value is added to the Forwarding Information Base (FIB).
See the
information.
Use the command distance ospf to set the distance for an entire category of OSPF
routes, rather than the specific routes that pass an access list.
Use the command distance <1-255>, with no other parameter, to set the same
distance for all OSPF route types.
The no variant of this command sets the administrative distance for all OSPF routes
to the default of 110.
distance <1-255>
Syntax
distance ospf {external <1-255>|inter-area <1-255>|intra-area
<1-255>}
no distance {ospf|<1-255>}
Default The default OSPF administrative distance is 110. The default Administrative
Distance for each type of route (intra, inter, or external) is 110.
Mode Router Configuration
Usage The administrative distance rates the trustworthiness of a routing information
source. The distance could be any integer from 0 to 255. A higher distance value
indicates a lower trust rating. For example, an administrative distance of 255
indicates that the routing information source cannot be trusted and should be
ignored.
Use this command to set the distance for an entire group of routes, rather than a
specific route that passes an access list.
Examples To set the following administrative distances for route types in OSPF 100:
•
C613-50186-01 Rev B
Route Selection Feature Overview and Configuration Guide
Parameter Description
<1-255>
Specify the Administrative Distance value for OSPF routes.
external
Sets the distance for routes from other routing domains, learned by
redistribution. Specify an OSPF external distance in the range <1-255>.
inter-area Sets the distance for all routes from one area to another area.
Specify an OSPF inter-area distance in the range <1-255>.
intra-area Sets the distance for all routes within an area.
Specify an OSPF intra-area distance in the range <1-255>.
20 for inter-area routes
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
for more
929