Debug Ppp - Allied Telesis AR2050V Command Reference Manual

PPP C
OMMANDS

DEBUG PPP

debug ppp
Overview Use this command to enable PPP protocol debugging on an optionally specified
PPP interface or range of PPP interfaces to analyze PPP behavior when diagnosing
PPP connectivity issues. If no interface is specified then debugging for all PPP
interfaces is enabled.
Use the no variant of this command to disable PPP protocol debugging on the
specified PPP interface. If no PPP interface is specified then PPP debugging for all
PPP interfaces is disabled.
debug ppp [interface <ppp-interface-list>]
Syntax
no debug ppp [interface <ppp-interface-list>]
Default No diagnostic messages are enabled for PPP debugging. PPP debugging is
disabled by default.
Mode Global Configuration and Privileged Exec
Usage Debugging messages are sent to the logging system and can be viewed in log
output, filtered in permanent or buffered logs, and viewed on the terminal using
the
debugging ppp
Note that debugging output for PPP shows packet debugging and events
debugging, see output below.
Note that disabling all debugging with the
commands also disables PPP debugging configured with this command.
Note that the negated form of this command is an alias of the
command.
Examples To enable PPP debugging on all PPP interfaces and send diagnostic messages to
the system log, use the below command:
awplus#
To enable PPP debugging on PPP interfaces ppp0 through ppp2 and display them
on the console, use the below commands:
awplus#
awplus#
C613-50186-01 Rev B
Parameter
<ppp-interface- list>
terminal monitor command. See the status of PPP debugging with the
command.
debug ppp
terminal monitor
debug ppp interface ppp0-ppp2
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specify a PPP interface or a range of PPP interfaces in
the range ppp<0-255>. Use a hyphen between PPP
interfaces to include all PPP interfaces in a given range,
or use commas between PPP interfaces to specify
non-contiguous PPP interfaces.
no debug all
show
or the undebug all
undebug ppp
577