Allied Telesis AR2050V Command Reference Manual page 579

PPP C
OMMANDS
DEBUG PPP
Output of event Figure 19-2: Example output from the debug ppp command for a PPP interface
debugging
To record messages relating to PPP packets in the buffered log, first configure a
buffered log filter to select the messages using the commands:
awplus#
awplus(config)#
awplus(config)#
Then configure PPP debugging, using the below command:
awplus#
To disable PPP debugging for all PPP interfaces, use the below command:
awplus#
Related terminal monitor
Commands
encapsulation ppp
no debug all
ppp authentication
show debugging ppp
show interface (PPP)
undebug all
C613-50186-01 Rev B
awplus#terminal monitor 
awplus#debug ppp interface ppp0 

05:35:43 awplus pppd[24767]: [ppp0] [05:35:43.710] using channel 1 
05:35:43 awplus pppd[24767]: [ppp0] [05:35:43.712] Using interface
ppp0 
05:35:43 awplus pppd[24767]: [ppp0] [05:35:43.712] Connect: ppp0
<--> hdlc0 
05:35:46 awplus PPP: IP is up on interface ppp0 [local-IP:
192.168.1.2, remote-IP: 
192.168.1.1] 
05:35:46 awplus PPP: IPCP [ppp0]: add IP interface [IP-addr:
192.168.1.2, mask: ] 
05:35:46 awplus PPP: IPCP [ppp0]: add host route [peer-IP:
192.168.1.1] 
05:35:47 awplus PPP: IPCP [ppp0]: add domain name server [DNS:
1.1.1.1] 
05:35:47 awplus PPP: IPCP [ppp0]: add domain name server [DNS:
2.2.2.2]
configure terminal
log buffered level debug program pppd
end
debug ppp
no debug ppp
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
579