Ppp Authentication - Allied Telesis AR2050V Command Reference Manual

PPP C
OMMANDS

PPP AUTHENTICATION

ppp authentication
Overview Use this command in Interface Configuration mode for a PPP interface to configure
PAP (Password Authentication Protocol), CHAP (Challenge Authentication
Protocol), or EAP (Extensible Authentication Protocol).
Use the no form of this command in Interface Configuration mode for a PPP
interface to disable all PAP, CHAP, and EAP authentication for a specified PPP
interface.
ppp authentication {eap|chap|pap}
Syntax
no ppp authentication
Default There is no PPP authentication protocol defined or configured to a PPP interface
by default.
Mode Interface Configuration for a PPP interface
To enable PPP PAP authentication on the PPP interface ppp0, enter the
Examples
commands:
awplus#
awplus(config)#
awplus(config-if)#
To enable PPP CHAP authentication on the PPP interface ppp0, enter the
commands:
awplus#
awplus(config)#
awplus(config-if)#
To enable PPP EAP authentication on the PPP interface ppp0, enter the
commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50186-01 Rev B
Parameter
eap
chap
pap
configure terminal
interface ppp0
configure terminal
interface ppp0
configure terminal
interface ppp0
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specify this parameter to enable EAP on a PPP interface
Specify this parameter to enable CHAP on a PPP interface.
Specify this parameter to enable PAP on a PPP interface.
ppp authentication pap
ppp authentication chap
ppp authentication eap
598