PPP C
OMMANDS
SHOW DEBUGGING PPP
show debugging ppp
Overview
Use this command to display PPP debug settings for optionally specified PPP
interfaces. If no PPP interfaces are specified then PPP debug settings are shown for
all available PPP interfaces.
show debugging ppp [interface <0-255>]
Syntax
Mode
Privileged Exec
Examples
The following example shows how to display PPP debug information for PPP
interface ppp0:
awplus#
The following example shows how to display PPP debug information for PPP
interface ppp0 through ppp2:
awplus#
The following example shows how to display PPP debug information for PPP
interface ppp0 and ppp2:
awplus#
The following example shows how to display PPP debug information for all
available PPP interfaces:
awplus#
Figure 19-6: Example output from the show debugging ppp command
Related
debug ppp
Commands
no debug all
undebug all
show interface (PPP)
C613-50186-01 Rev B
Parameter
<0-255>
show debugging ppp interface ppp0
show debugging ppp interface ppp0-ppp2
show debugging ppp interface ppp0,ppp2
show debugging ppp
awplus# show debugging ppp
PPP debugging status:
PPP debug on interface ppp0: enabled
PPP debug on interface ppp1: disabled
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specify a PPP interface or a range of PPP interfaces in the
range ppp<0-255>. Use a hyphen between PPP
interfaces to include all PPP interfaces in a given range,
or use commas between PPP interfaces to specify
non-contiguous PPP interfaces.
613