Allied Telesis AR2050V Command Reference Manual page 1316

BGP BGP4+ C
AND OMMANDS
SET COMMUNITY
Mode Route-map Configuration
Usage This command is valid for BGP update messages only.
To use entry 3 of the route map called rmap1 to put matching routes into the no-
Examples
advertise community, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
To use entry 3 of the route map called rmap1 to put matching routes into several
communities, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
no-export
To use entry 3 of the route map called rmap1 to put matching routes into a single
AS community numbered 16384, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
Related match community
Commands
route-map
set aggregator
set comm-list delete
set extcommunity
show route-map
C613-50186-01 Rev B
Parameter Description
none
The device removes the community attribute from matching
update messages.
additive
The device adds the specified community value to the update
message's community attribute, instead of replacing the existing
attribute. By default this parameter is not included, so the device
replaces the existing attribute.
configure terminal
route-map rmap1 permit 3
configure terminal
route-map rmap1 permit 3
configure terminal
route-map rmap1 permit 3
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
set community no-advertise
set community 10:01 23:34 12:14
set community 16384 no-export
1316