Ip Ospf Network - Allied Telesis AR2050V Command Reference Manual

OSPF C
OMMANDS

IP OSPF NETWORK

ip ospf network
Overview This command configures the OSPF network type to a type different from the
default for the particular VLAN interface.
The no variant of this command returns the network type to the default for the
particular VLAN interface.
Syntax ip ospf network [broadcast|non-broadcast|point-to-point|
point-to-multipoint]
no ip ospf network
The default is the broadcast OSPF network type for a VLAN interface.
Default
Mode Interface Configuration for a VLAN interface or a PPP interface.
Usage This command forces the interface network type to the specified type. Depending
on the network type, OSPF changes the behavior of the packet transmission and
the link description in LSAs.
Example The following example shows setting the network type to point-to-point on the
VLAN interface vlan2.
awplus#
awplus(config)#
awplus(config-if)#
The following example shows setting the network type to point-to-point on the
PPP interface ppp0.
awplus#
awplus(config)#
awplus(config-if)#
C613-50186-01 Rev B
Parameter
broadcast
non-broadcast
point-to-multipoint
point-to-point
configure terminal
interface vlan2
configure terminal
interface ppp0
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Sets the network type to broadcast.
Sets the network type to NBMA.
Sets the network type to point-to-multipoint.
Sets the network type to point-to-point.
ip ospf network point-to-point
ip ospf network point-to-point
945