Set Metric - Allied Telesis AR2050V Command Reference Manual

R M C
OUTE AP OMMANDS

SET METRIC

set metric
Overview Use this command to add a metric set clause to a route map entry.
When a routeor BGP update message matches the route map entry, the device
takes one of the following actions:
•
•
Use the no variant of this command to remove the set clause.
set metric {+<metric-value>|-<metric-value>|<metric-value>}
Syntax
no set metric [+<metric-value>|-<metric-value> |<metric-value>]
Default The default metric value for routes redistributed into OSPF and OSPFv3 is 20.
Mode Route-map Configuration
Usage For BGP, if you want the device to compare MED values in update messages from
peers in different ASes, also enter the command
device always compares MED values in update messages from peers in the same
AS.
This command is valid for:
•
•
•
Note that defining the OSPF metric in a route map supersedes the metric defined
using a
information, see the
OSPF Feature Overview and Configuration
C613-50186-01 Rev B
changes the metric(or for BGP, the MED attribute value) to the specified
value, or
adds or subtracts the specified value from the metricor MED attribute, if you
specify +or- before the value (for example, to increase the metric by 2, enter
+2)
Parameter Description
+
Increase the metricor MED attribute by the specified amount.
-
Decrease the metricor MED attribute by the specified amount.
<metric-value> <0-4294967295>
The new metricor MED attribute value, or the amount by which
to increase or decrease the existing value.
OSPF routes
routes in BGP update messages
RIP routes.
redistribute (OSPF)
OSPFv3 Feature Overview and Configuration Guide
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
bgp
or a redistribute (IPv6 OSPF)
Guide.
always-compare-med. The
command. For more
and the
1413