Lucent DDM-2000 OC-3 User And Service Manual page 35

IXL-001
: Acceptance
Page 1 of 2
FIND YOUR JOB IN THE LIST BELOW. . . . . . . . . . THEN GO TO
Acceptance Procedures (Shelf Equipped)
NOTE:
The following procedures are for use in testing the DDM-2000 OC-3 Multiplexer
system after another organization has equipped it. The procedures test the
DDM-2000 OC-3 system after all circuit packs have been installed and the shelf
is looped back or after a system has been established end-to-end. They are not
intended to be used for initial system turnup or in establishing an end-to-end
system. System Turnup procedures are found in this manual under the System
Turnup/Circuit Order tab.
Test (Accept) DDM-2000 OC-3 Multiplexer (Equipped) —
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Acceptance: NTP-002
Test (Accept) DDM-2000 OC-3 Multiplexer shelf
(Looped Back) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Acceptance: NTP-003
Test (Accept) End-to-End DDM-2000 OC-3
System (Network) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Acceptance: NTP-004
Acceptance Procedures (Shelf Unequipped)
NOTE:
Procedures for installing and testing DDM-2000 OC-3 system bays, shelves,
and cables are found in 363-206-204, DDM-2000 OC-3 Multiplexer Installation
Manual .
Acceptance Task Index
DDM-2000 OC-3 M
Issue 3, June 2001
ULTIPLEXER
363-206-285