Lucent DDM-2000 OC-3 User And Service Manual page 925

DLP-526
: Detailed Level Procedure
Page 1 of 8
Condition and Connect Modems to Establish
Communication From Remote CIT Location
!
1.
CAUTION:
DDM-2000 circuit packs contain static sensitive components which can
be damaged by electrostatic discharge. A static ground wrist strap must
be worn when handling the circuit packs. See electrostatic discharge
considerations in Trouble Clearing: TAD-100 .
NOTE:
This procedure may be used to connect modems and a craft interface
terminal (CIT) to the DDM-2000 OC-3 Multiplexer system for use in
provisioning the system from a remote location.
NOTE:
This procedure must be performed at both the DDM-2000 location and
remote CIT location to set the parameters of modems and terminal.
NOTE:
Modems supporting a large set of options and error detection capabilities
may require other options to be set before using the modems to
download generic software. Refer to manufacturer's manuals for
instructions on setting modem parameters.
DDM-2000 OC-3 M
Issue 2, February 2000
ULTIPLEXER
363-206-285