Lucent DDM-2000 OC-3 User And Service Manual page 669

TAP-107
: Trouble Clearing
Page 25 of 28
Table B – RTRV-ALM Message Descriptions (Continued)
Description
lockout of service
manual switch
manual sync. mode switch
MXRVO CP failed
OC12 connector failed
OHCTL CP failed
OHCTL standby boot fail
OLIU CP failed
program installation IP
lan program installation IP
Alarm
Level
ABN
ABN
ABN
CR or MN Internal equipment failure of the specified MXRVO
MN
MJ
MN
CR or MN Internal equipment failure of the specified OLIU
Status
Status
DDM-2000 OC-3 M
Issue 2, February 2000
Meaning
When associated with a LOW SPEED service slot,
this message means that the specified LOW
SPEED service slot is active and will not be
switched to protection. The lockout will remain in
effect until the protection switch is reset. (See the
switch-ls: command.)
The specified DS1 circuit pack is manually
switched to protection. The manual switch will
remain in effect until the protection switch is reset
or until a failure occurs and an automatic switch
preempts the manual switch. (See the
switch-ls: command.)
The synchronization mode has been manually
switched to holdover or free running and will
remain in that mode until the switch request is
reset. (See the switch-sync: command.)
circuit pack.
Failure or removal of the OC-12 24G-U/24H-U or
29G-U/29H-U OLIU faceplate connector which
carries STS-1/STS-3c ring pass through traffic on
the OC-12 ring interface on the OC-3 shelf.
Internal equipment failure of the OHCTL circuit
pack.
OHCTL circuit pack failed during local or remote
software download.
circuit pack.
This system is being used to install software into
another system. If this procedure is interrupted
prior to completion, the remote systems' control
circuit packs will likely become inoperable until
another install program attempt is successful.
Starting with OC-3 Release 15, this message will
appear in the alarm report of a Network Element
while it is the source of an IMA LAN software
download (cpy-prog: or remote ins-prog:)
into another Network Element. The initiating of the
apply: command for the IMA LAN software will
cause this event as well.
ULTIPLEXER
363-206-285