Lucent DDM-2000 OC-3 User And Service Manual page 112

NTP-005
: System Turnup
Page 4 of 4
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
9. Make necessary STS-1 cross-connections for each node in the
network.
A. Single Ring Configuration
B. Dual Ring Interworking (DRI) Configuration
C. Single/Dual OC-3/OC-48 Configuration
D. Single/Dual OC-3/OC-12 Configuration
10.
NOTE:
For a DS3 circuit in a path protected ring network, the
sw-path-sts1:address command must be used at the
terminating nodes [and dual ring interworking (DRI) nodes in
a DRI ring network] to switch the active STS-1 (DS3) path to
repeat this test on the other path(s).
Perform DS3 end-to-end transmission test for each circuit being
put into service (optional).
A. Single Ring Configuration
B. Dual Ring Interworking (DRI) Configuration
C. Single/Dual Homing Ring Configuration
11. Use the set-t3: command to set the characteristics of the DS3
port of the circuit being established.
12. Use the rtrv-state-eqpt: command to determine the port
state of the DS3 port of the circuit being established.
13.
NOTE:
If a port is in the nmon (n state, the signal is not monitored or
alarmed. The port will not automatically go to the in
service (i) state when a signal is detected as it will in the
auto (a) state. In the nmon state, the port must be returned
to the auto state, using the set-state-t3: command, to
turn on monitoring of signal failures and before any circuit
packs associated with that port can be removed from the
equipment list by the upd command.
Use the set-state-t3: command to set the port state of the
DS3 port of the circuit being established.
DDM-2000 OC-3 M
Issue 2, February 2000
ULTIPLEXER
363-206-285
DLP-546
DLP-550
DLP-559
DLP-560
DLP-511
DLP-553
DLP-511