Lucent DDM-2000 OC-3 User And Service Manual page 942

DLP-528
: Detailed Level Procedure
Page 6 of 12
21. NOTE:
The checkpgm command may take several seconds to complete.
Execute the checkpgm command to check the version number of the program
you are installing and install each diskette when prompted.
Response:
Comment:
22. NOTE:
The OC-3 shelf's rear access CIT port is configured for a modem. A null
modem adapter is required to use this port with the PC. The cable from
the CIT port on the DDM-2000 shelf must be connected to the COM1 or
COM2 RS-232 port of the PC.
Connect PC to front CIT port by connecting one end of an RS-232 cable to the
COM ( ) of the PC and the other end of the cable to the front or rear CIT port
in OC-3.
23. NOTE:
The FE ID display on the remote SYSCTL, must show on of the following,
preceding software installation. If other conditions appear, they would
represent failure conditions that will not allow a remote software
download.
• If the cpy-prog: command encounters a "P." in the target NE during
initial handshake (before the cpy-prog: command is confirmed),
the request is denied and the following denial message is displayed
at the source NE. You may be able to download software from
another shelf or locally.
Checking presence of required files . . . .
Checking IMA LAN program version a.b.c.
Checking document integrity
..........................
/* All files OK
Time required is approximately 15 seconds or less, if
using hard drive or 30 seconds per floppy disk, if using
floppy drive.
DDM-2000 OC-3 M
Issue 2, February 2000
*/
ULTIPLEXER
363-206-285