Lucent DDM-2000 OC-3 User And Service Manual page 645

TAP-107
: Trouble Clearing
Page 1 of 28
Craft Interface Terminal (CIT)
1.
NOTE:
The Remote NE Status feature is valid starting with OC-3 Release 15.0
and must be enabled using the rnestat parameter of the set-ne:
command.
NOTE:
It is assumed that a CIT is available and that there is a failure at a far end
node (as indicated by an FE ACTY LED on the local system or by the
Source Address of farend in the local Active Alarms and
Status Report).
Connect the CIT to the connector on the User Panel or remote login to the
near-end system, if not already performed.
Reference: DLP-521
2.
NOTE:
The Active Alarms and Status Report is output automatically
following CIT log in. The report shown in Figure 1 is an example that
shows several entries. There may be only one entry in the actual report.
Note the information in the Source Address and Description columns for
the top entry/entries above the first single-dashed line in the Active Alarms
and Status Report (Figure 1) (for example,
MINOR
/* Active Alarms and Status Report
=============================================================
Alarm Source
Level Address
=============================================================
MINOR farend
MINOR farend
-------------------------------------------------------------
ne-acty m1-1-1-1
*/
Figure 1 – Example of Active Alarms and Status Report
Clear Far End Alarm Using
farend MM-DD HH:MM:SS
Date Time
Detected
MM-DD HH:MM:SS
MM-DD HH:MM:SS
MM-DD HH:MM:SS
DDM-2000 OC-3 M
Issue 2, February 2000
- SiteXNE1)
Srv Description
- SiteXNE1
- SiteYNE1
inc. VT AIS
ULTIPLEXER
363-206-285