Lucent DDM-2000 OC-3 User And Service Manual page 254

NTP-026
: Circuit Order
Page 6 of 10
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
Use the ent-crs-vt1: or ent-crs-sts1: command at the
new shelf to make all required pass-through cross-connections
(for example, ent-crs-vt1:m-1-1-1,m-1-1-1 or
ent-crs-sts1:m-1,m-1). Pass-through cross-connections
must be made at the new shelf to correspond to each terminating
cross-connection present on every shelf in the ring network.
(See Figure 1.)
9.
NOTE:
If Kbyte or Sbyte (sync messaging) is enabled for the
main-1 and main-2 optical interfaces at any node in a ring,
it must be enabled at all nodes of the ring.
NOTE:
The rtrv-oc3: or rtrv-oc12: command retrieves the
OC-3 Line Provisioning Report or OC-12 Line
Provisioning Report. This report displays the
provisioned configuration of OC-3 or OC-12 lines. See the
Commands and Reports section of this manual for a
description of the rtrv-oc3: or rtrv-oc12: command
format.
Use the rtrv-oc3: or rtrv-oc12: command to obtain the
OC-3 Line Provisioning Report or OC-12 Line
Provisioning Report and verify if Kbyte/Sbyte is enabled or
disabled. Use the set-oc3: or set-oc12: command to enable
or disable the Kbyte/Sbyte parameter, as required.
DDM-2000 OC-3 M
Issue 2, February 2000
ULTIPLEXER
363-206-285