Table of Contents
Advertisement
363-206-285
Issue 2, February 2000
3.
NOTE:
Local alarm or status conditions have a Source Address of the local
slot, line, port, channel, path, cross-connection, or operations interface
(DCC, X.25, etc.) where the event occurred. (See Addresses in the
Commands and Reports section of this manual.) Use the rtrv-alm:
command to get another report, if necessary.
Note the trouble indication in the Description column of the Active
Alarm and Status Report, starting with the highest alarm level (Minor)
listed in the Alarm Level column.
4.
Use opr-aco; command to silence active audible office alarms, if required.
5.
Find the trouble description in Table A for the highest alarm level and go to the
indicated step or procedure.
DDM-2000 OC-3 M
Trouble Clearing:
ULTIPLEXER
TAP-112
Page 2 of 16
Hide quick links:
Advertisement
Table of Contents
