Lucent DDM-2000 OC-3 User And Service Manual page 625

TAP-102
:Trouble Clearing
Page 9 of 14
16. Use CIT and reset command to reset SYSCTL at the near end or unplug and
reseat the SYSCTL.
17. Is the FAULT LED on the OHCTL circuit pack still flashing (section DCC
channel failed)?
If YES, then continue with Step 18.
If NO, then STOP. YOU HAVE COMPLETED THIS PROCEDURE.
18. If possible, use CIT and rlgn command to log in to the far-end terminal
(DLP-522) and use the reset command to reset SYSCTL at the far end.
19. Is the FAULT LED on the OHCTL circuit pack still flashing (section DCC
channel failed)?
If YES, then proceed to Step 24.
If NO, then STOP. YOU HAVE COMPLETED THIS PROCEDURE.
20.
NOTE:
Unseating and reseating the SYSCTL performs a reset procedure which
restarts the software program.
Unseat and reseat SYSCTL circuit pack. Do not depress UPD/INIT button.
21. Is the FAULT LED on the affected circuit pack still flashing?
If YES, then continue with Step 22.
If NO, then STOP. YOU HAVE COMPLETED THIS PROCEDURE.
22. Obtain a CIT and repeat this procedure.
23. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
DDM-2000 OC-3 M
Issue 2, February 2000
ULTIPLEXER
363-206-285