Lucent DDM-2000 OC-3 User And Service Manual page 945

363-206-285
Issue 2, February 2000
30. NOTE:
If floppies are being used, ensure the first (number 1) diskette is installed
in floppy drive. If hard drive is being used, ensure you are in the correct
directory.
Enter the command ins-prog:tid
Where tid
Response:
31. Was response correct?
If YES, then continue with Step 32.
If NO, then do Trouble Clearing: TAP-122.
32. Enter a y or yes and a carriage return to execute the program. Software
download may take up to 5 minutes.
Response:
= the target identifier (shelf name) for the far-end
DDM-2000 shelf having the new program installed.
/* Testing For IMA LAN Program
Installation... */
After several seconds, the PC prints a Caution!
message followed by the prompt:
Execute? y/n =.
ABN LED lights on User Panel. A "P." is displayed in
SYSCTL FE ID display in the far-end shelf receiving the
program (for uncompressed executing copy download, not
if dormant copy is being loaded). PC starts download and
prints the following message:
Searching for optimal transfer rate.
Handshake established at <baudrate> baud.
In progress . . . .
The dots continue to print until program installation is
complete. If floppy disks are being used, insert each
diskette when prompted. After installation is completed,
the PC prints the following completion message:
lan ins-prog:TID COMPLD
/* IMA LAN Generic program a.b.c is
installed */
The SYSCTL resets, and the terminal is logged off the
system. The LEDs go off on the User Panel and SYSCTL.
DDM-2000 OC-3 M
Detailed Level Procedure:
ULTIPLEXER
DLP-528
Page 9 of 12