Lucent DDM-2000 OC-3 User And Service Manual page 203

NTP-022
: System Turnup
Page 3 of 8
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
4.
NOTE:
If Kbyte or Sbyte (sync messaging) is enabled for the
main-1 and main-2 optical interfaces at any node in a ring,
it must be enabled at all nodes of the ring.
NOTE:
The rtrv-oc3: or rtrv-oc12: command retrieves the
OC-3 Line Provisioning Report or OC-12 Line
Provisioning Report. This report displays the
provisioned configuration of OC-3 or OC-12 lines. See the
Commands and Reports section of this manual for a
description of the rtrv-oc3: or rtrv-oc12: command
format.
Use the rtrv-oc3: or rtrv-oc12: command to obtain the
OC-3 Line Provisioning Report or
OC-12 Line Provisioning Report and verify if Kbyte/Sbyte
is enabled or disabled. Use the set-oc3: or set-oc12:
command to enable or disable the Kbyte/Sbyte parameter, as
required.
5.
NOTE:
If Sync Autoreconfiguration is enabled, Kbyte/Sbyte must
also be enabled.
NOTE:
If Sync Autoreconfiguration is enabled at any line-timed node
in a ring, it must be enabled at all line-timed nodes of a ring.
NOTE:
The rtrv-sync: command retrieves the
Synchronization
provisioning and operational information on the
synchronization attributes of the DDM-2000. See the
Commands and Reports section of this manual for a
description of the rtrv-sync: command format.
Use the rtrv-sync: command to obtain the
Synchronization Report and verify if Sync
Autoreconfiguration is enabled or disabled. Use the set-sync:
command to enable or disable the Sync Autoreconfiguration
parameter and to set sync source, as required.
Report. This report displays the
DDM-2000 OC-3 M
Issue 2, February 2000
ULTIPLEXER
363-206-285