Table of Contents
Advertisement
DLP-512
: Detailed Level Procedure
Page 8 of 10
Table A – DDM-2000 OC-3 Parameters Provisionable Via the CIT (Contd)
Parameter
Cross-connection type
Expected STS-1 path
trace message
Outgoing STS-1 path
trace message
Notes:
1.
Default means factory default (the CIT prompts display current provisioned values).
2.
To view the current values, precede these commands with rtrv- instead of set-
†
Parameter can be set for each port.
‡
AUTO means the port or channel is ready to be automatically provisioned via signal detection.
§
noOverride means read and use switch settings on circuit pack.
¶
Track means the source for iming will be selected from the active received OC-3 line specified.
**
This command is available to privileged users only.
†† Rings.
‡‡ Setting this parameter also affects DS1 output source and DS1 sync output mode. See set-sync
command in Section 11, "Commands and Reports".
¶¶ This parameter is not applicable to the BBG20 TMUX circuit pack.
*** Parameters can be set for each channel.
††† Ring releases. Requires 22D-U/22G-U/22G2-U/22G3-U OLIUs.
‡‡‡ Ring releases.
§§§ With 24G-U/24H-U/29G-U/29H-U OLIUs in MAIN slots.
¶¶¶ This parameter is only applicable to the BBG20 TMUX circuit pack.
Range
twoway
62 characters
62 characters
DDM-2000 OC-3 M
Issue 2, February 2000
Default
(Note 1)
twoway
see command pgs.
see command pgs.
ULTIPLEXER
363-206-285
Command (Note 2)
ent-crs-sts3c
set-trace-sts1
set-trace-sts1
Hide quick links:
Advertisement
Table of Contents
