Lucent DDM-2000 OC-3 User And Service Manual page 940

DLP-528
: Detailed Level Procedure
Page 4 of 12
Enter the command cpy-prog:tid,pgmtype=lansw;
Where tid
Response:
11. Was response correct?
If YES, then continue with Step 12.
If NO, then do Trouble Clearing: TAP-122.
12. Enter a y or yes and a carriage return to execute the program. Software
download may take up to 7-10 minutes.
Response:
13. Was response correct?
If YES, then proceed to Step 36.
If NO, then continue with Step 14.
14. Wait approximately 10 minutes for network to stabilize then repeat this
procedure from Step 8. If the second attempt to download software fails, then
do Trouble Clearing: TAP-122. You may have to go to the remote site.
15. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
= the target identifier (shelf name) for the remote
DDM-2000 shelf receiving the new program and
pgmtype represents the Program Type to be copied
(lansw).
/* Testing For IMA LAN Program copy... */
After several seconds, the PC prints a Caution!
message followed by the prompt:
Execute? y/n =.
ABN and NE ACTY LEDs lights on User Panel. A "P." is
displayed in SYSCTL FE ID display in the far-end shelf
receiving the program. Download begins and the
following message is displayed:
In progress . . . .
The dots continue to print until program installation is
complete. After installation is completed, the PC prints the
following completion message:
lan cpy-prog:TID COMPLD
/* IMA LAN Generic program a.b.c is
installed */
The LEDs go off on the User Panel and SYSCTL.
DDM-2000 OC-3 M
Issue 2, February 2000
ULTIPLEXER
363-206-285