Lucent DDM-2000 OC-3 User And Service Manual page 812

DLP-512
: Detailed Level Procedure
Page 2 of 10
set-attr-env
set-attr-cont
set-date
set-fecom
set-lgn
set-link
set-ne
set-passwd
set-pmthres-line Sets the thresholds of the line performance
set-pmthres-sect Sets the thresholds of the section performance
set-pmthres-t1
set-pmthres-t3
set-pmthres-sts1 Sets the STS-1 path performance parameter
Names and sets alarm level of miscellaneous discrete
input points at RT only.
Names miscellaneous discrete control output points at
RT only.
Sets date and time.
Enables or disables far end communication
(DCC/LAN) over the data communication channel and
sets Network Side/User Side parameters.
Enters, edits, and deletes logins and passwords.
Privileged users can change other users' passwords
by using this command.
Sets length of page output on the CIT.
Sets the name [Target Identifier (TID)] of the network
element. Designates a shelf as an alarm gateway
network element (AGNE) and sets alarm group
numbers. Designates the Shelf numbers and
designates the Central Office/Remote Terminal
parameter. Sets the Idle Channel Signal parameter.
Sets or changes a users' password. All users can
change their own passwords.
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
Sets the thresholds of the DS1 performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
Sets the thresholds of the DS3 performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
thresholds. Available only in Release 2 or later
software.
DDM-2000 OC-3 M
Issue 2, February 2000
ULTIPLEXER
363-206-285