Lucent DDM-2000 OC-3 User And Service Manual page 290

NTP-029
: Circuit Order
Page 22 of 22
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
34.
NOTE:
If Sync Autoreconfiguration is enabled, Kbyte/Sbyte must
also be enabled.
NOTE:
If Sync Autoreconfiguration is enabled at any line-timed node
in a ring, it must be enabled at all line-timed nodes of a ring.
NOTE:
The rtrv-sync: command retrieves the
Synchronization
provisioning and operational information on the
synchronization attributes of the DDM-2000. See the
Commands and Reports section of this manual for a
description of the rtrv-sync: command format.
Use the rtrv-sync: command to obtain the
Synchronization Report and verify if Sync
Autoreconfiguration is enabled or disabled. Use the set-sync:
command to enable or disable the Sync Autoreconfiguration
parameter, as required.
35. The ring configuration is now complete and new nodes may be
added as required [NTP-026].
Report. This report displays the
DDM-2000 OC-3 M
Issue 2, February 2000
ULTIPLEXER
363-206-285