Lucent DDM-2000 OC-3 User And Service Manual page 102

363-206-285
Issue 2, February 2000
DO ITEMS BELOW IN ORDER LISTED . . . . .FOR DETAILS, GO TO
2.
NOTE:
The rtrv-eqpt: command retrieves the Equipage and
Version Report. This report lists the circuit pack type
and version information for one or more slots. See the
Commands and Reports section of this manual for a
description of the rtrv-eqpt: command format.
At each DDM-2000 OC-3 terminating end, use the rtrv-eqpt:
command to obtain the Equipage and Version Report and
verify that the proper service and protection (if required) MXRVO
(STS1E) circuit packs have been installed in FUNCTION UNITS
group(s) (A, B, or C) being put into service.
3. At the DS1 terminating node(s) of the circuit being established,
determine which DS1 port(s) is to be put into service and what
options are to be selected.
4.
NOTE:
The rtrv-t1: command retrieves the T1 Port
Provisioning Report. This report lists information
about each DS1 port. This information includes attributes
set by the set-t1: command. See the Commands and
Reports section of this manual for a description of the
rtrv-t1: command format.
At each DS1 terminating node, use the rtrv-t1: command to
obtain the T1 Port Provisioning Report and verify the
hardware and software option settings.
DDM-2000 OC-3 M
System Turnup:
ULTIPLEXER
NTP-004
Page 2 of 8