363-206-285
Issue 2, February 2000
NOTE:
If local procedures prohibit you from doing the init-pm:reg=all
command, you may perform the following in Steps 5 and 6. Use the
rtrv-pm-line: command to obtain the line performance monitoring
status report, note the readings on the current time line in the report,
wait 20 seconds and then obtain another report. There should be no
change in readings from the first report.
Enter the command init-pm:reg=all, if allowed.
4.
Wait 20 seconds.
5.
Enter one of the following commands:
• rtrv-pm-line:main-1 if service line is being tested.
• rtrv-pm-line:main-2 if protection line is being tested.
• rtrv-pm-line:main-all if both lines are being tested.
Response:
/* Line Performance Monitoring Status Report
Last initialized:
========================================================================
Address
Start
Time
========================================================================
address
time
.
.
.
.
.
.
------------------------------------------------------------------------
address
time
.
.
.
.
.
.
*/
The following CIT report will indicate the status of the
equipment. The current time line should indicate that
there are no errors. Other time lines may exist with
numbers greater than zero. (The Commands and Reports
section of this manual under RTRV-PM-LINE describes
this report.)
day registers at yy-mm-dd hh:mm:ss
quarter hour registers at yy-mm-dd hh:mm:ss
B2 CV
B2 ES
B2 ESA
B2 SES
B2 ESB
nn
nn
.
.
.
.
.
.
nn
nn
.
.
.
.
.
.
DDM-2000 OC-3 M
Detailed Level Procedure:
B2 UAS
PSC-L
nn
nn
nn
.
.
.
.
.
.
.
.
.
nn
nn
nn
.
.
.
.
.
.
.
.
.
ULTIPLEXER
DLP-515
Page 2 of 4
PJC
nn
.
.
.
nn
.
.
.