Table of Contents
Advertisement
363-206-285
Issue 3, June 2001
DO ITEMS BELOW IN ORDER LISTED . . . . .FOR DETAILS, GO TO
2.
Verify that the host WaveStar TDM 2.5G shelf is equipped with
Release 2.0 or later software. If not equipped with Release 2.0 or
later software, upgrade the WaveStar TDM 2.5G host shelf with
proper software. Verify that the DDM-2000 OC-3 shelves are
equipped with TARP Release 15 ring software.
3.
Determine the optical loss of each optical span from office
records or by making the required measurements.
4.
At WaveStar TDM 2.5G, verify/provision the WaveStar TDM 2.5G
low speed OC-3/OC-12 slots to "1+1", enable DCC channels, and
install circuit packs. (See Create New Optical Port Protection
Group, T 302 procedure in 365-371-102, WaveStar TDM 2.5G,
User/Service Manual) .
5.
Use the rtrv-oc3/set-oc3 or rtrv-oc12/set-oc12
command at the remote DDM-2000 OC-3 shelf to verify/set
application (dcc) parameter for the OC-3/OC-12 MAIN slots
being used for this OC-3/OC-12 linear extension. For example,
set-oc3:main,dcc=identical or
set-oc12:main,dcc=identical
DDM-2000 OC-3 M
System Turnup:
ULTIPLEXER
NTP-059
Page 2 of 12
Hide quick links:
Advertisement
Table of Contents
