Lucent DDM-2000 OC-3 User And Service Manual page 962

363-206-285
Issue 2, February 2000
12. Enter the shelf number for the shelf being used for new program download.
Response:
13. NOTE:
After the system prompt (<), the system will respond normally to
commands entered. The "Commands and Reports" section of Volume 1
of this manual gives a description of the commands.
Use rtrv-ne: command to retrieve the name (tid) of the shelf having new
program installed or see TID in response above. .
14. Enter the command ins-prog:tid or
ins-prog:tid,prmtype=nesw
Where tid
Where pgmtype
Response:
PC responds with:
/*************************************
*
* Lucent Technologies
* DDM-2000 OC-3 Multiplexer
*
* Release a.b.c
*
*************************************/
TID date time
M rtrv-alm:all COMPLD
/* Active Alarms and Status Report
= the target identifier (shelf name) for the DDM-2000
shelf having the new program installed.
= the type of software you want to install.
/*\ Testing For Program Installation...\ */
After several seconds, the PC prints a Caution!
message followed by the prompt:
Execute? y/n =.
DDM-2000 OC-3 M
Detailed Level Procedure:
.
.
.
ULTIPLEXER
DLP-532
Page 8 of 14
*
*
*
*
*
*