Lucent DDM-2000 OC-3 User And Service Manual page 824

DLP-513
: Detailed Level Procedure
Page 4 of 20
Table B – BBF2 TGS Synchronization Provisioning Topologies (Contd)
NE 1
External - Mult
Line Timing
NOTE:
To set switch to ON, depress rocker or slide switch toward side labeled
ON in the figure. To set switch to OFF, depress rocker or slide switch
toward side labeled OFF in the figure.
Determine the timing mode from work order or office records. Refer to Table C
and Figure 2 and set the timing mode as required for the TGS circuit pack(s).
Table C – BBF2 TGS Timing Mode Switch Setting
Timing Mode
Free Running
DS1 External, MULT Mode
Line Timed
Invalid*
* If an invalid setting is selected, FAULT LED is lighted and an alarm is generated
unexpected CP type or unexpected CP switches)
NE 2
External - Mult This topology is used when both NE's have access to and
are receiving its timing from BITS clocks. The
recommendation is to have these BITS synchronized to
references which are traceable to the same PRS. If these
guidelines are followed the subnetwork created by these
two NE's would be operating synchronously. Note:
DDM-2000 systems are designed to operate in
pleisiochronous timing topologies. The DS1 output
generated by each NE is regenerated from the input DS1
timing reference and could be used to distribute this
reference to other shelves colocated in the same bay to
conserve ports on the BITS.
Line Timing Caution! This topology creates a timing loop and it is not
supported. The NE with access to an external timing
reference traceable to a PRS, if available, should be
provisioned for External - Mult. If the reference available is
an optical reference provision to Line Timing with the
proper source using the set-sync command. If automatic
synchronization reconfiguration is supported and enabled
in a system, both NEs will attempt to switch to another line
timing source, if available, to prevent a timing loop.
Switch S1 Settings
S1-3
ON
OFF
ON
OFF
DDM-2000 OC-3 M
Issue 2, February 2000
Application Comments
S1-4
ON
ON
OFF
OFF
ULTIPLEXER
363-206-285