Lucent DDM-2000 OC-3 User And Service Manual page 720

TAP-116
: Trouble Clearing
Page 4 of 6
15.
NOTE:
The new program installation may have failed because of faulty diskettes.
Disconnect PC and repeat program installation procedure. Use your backup
diskettes containing new generic program, if available. If new program
installation cannot be completed and the old program has been erased, one
the following procedures may be used to restore the old program or install a
different version program.
A. If a "P." was displayed in the FE ID display during a software download,
indications are that a portion of the program has been erased and you will
have to reinstall the program. You may be able to use the ins-prog:tid
or ins-prog:tid,pgmtype=nesw (R15) or cpy-prog:tid or
cpy-prog:tid,pgmtype=nesw (R15) command from a far-end shelf to
reload software. Go to the far-end shelf and establish session with a CIT.
Enter the ins-prog:tid or ins-prog:tid,pgmtype=nesw (R15) or
cpy-prog:tid or cpy-prog:tid,pgmtype=nesw (R15) command
where the tid is the tid (shelf name) for the failed shelf where you want
to install the old program.
B. If a "P." was displayed in the FE ID display during a software download
and you cannot load the program from the far-end, you can force the
download. To load another version of software, unseat and then reseat the
SYSCTL and immediately push and hold the FE SEL and UPD/INIT
buttons at the same time until a "P" appears in the FE ID display. Release
buttons and repeat the download procedure.
C. Replace the SYSCTL and OHCTL with ones that have compatible
software. [DLP-523]
D. If a "C" was displayed in the FE ID display after a software download,
indications are that the software loaded will not support the current
system transmission configuration. This indicates a problem with the
version of software you are trying to install, or you are trying to install a
version of software that does not support the system configuration that
you have. To load another version of software, unseat and then reseat the
SYSCTL and immediately push and hold the FE SEL and UPD/INIT
buttons at the same time until a "P" appears in the FE ID display. Release
buttons and repeat the download procedure.
If you need technical assistance, notify your supervisor, your local technical
support organization, or call Lucent Technologies RTAC, per local operating
instructions.
16. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
DDM-2000 OC-3 M
Issue 2, February 2000
ULTIPLEXER
363-206-285