DLP-522
: Detailed Level Procedure
Page 2 of 4
NOTE:
To set baud rate automatically if security has not been enabled, enter two
carriage returns (<cr>), two lowercase "a"s (aa), or two uppercase "A"s
(AA) after the login prompt. All other characters are ignored.
Enter command rlgn:tid
Where tid
Response:
3.
If security has been enabled, enter your login and password when you are
prompted.
If security has not been enabled, enter two carriage RETURNs.
Response:
4.
NOTE:
After the prompt, the remote system will respond normally to any
commands entered just as if you were physically connected to the remote
terminal.
See the Commands and Reports section of this manual for a description of the
commands formats.
= the target identifier (shelf or site/shelf name) of the
remote terminal.
CIT prompts with: login <
System responds with:
/*************************************
*
*
Lucent Technologies
*
DDM-2000 OC-3 Multiplexer
*
*
Release a.b.c
*
*************************************/
TID date time
M
rtrv-alm:all COMPLD
/* Active Alarms and Status Report
DDM-2000 OC-3 M
Issue 2, February 2000
.
.
.
ULTIPLEXER
363-206-285
*
*
*
*
*
*