Lucent DDM-2000 OC-3 User And Service Manual page 947

363-206-285
Issue 2, February 2000
42. NOTE:
Executing the apply command will cause the executing generic in the
addressed IMA LAN circuit pack(s) to be overwritten by the dormant
generic in the local NE.
NOTE:
The input format of the apply command:
apply:pgmtype=lansw,Address=AID,date=date,time=time,
action=install;
Execute the apply command at the shelf containing the IMA LAN circuit pack
to download dormant software. Dormant software download may take up to 2
minutes.
Response:
43. Was response correct?
If YES, then STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If NO, then proceed to Step 44.
44. NOTE:
If there is an indication that the apply command has failed on the
addressed circuit pack(s) or is in the hung state, the apply command
should be reattempted.
Execute the rtrv-alm command to know if the IMA LAN program installation
is still In progress (lan program installation IP), rtrv-hsty to
know if IMA LAN program Apply Failed (lan apply fail.), and rtrv-lan
to insure that the Apply Action is not listed for the address being checked.
45. Execute the apply command at the shelf to receive the software. Software
download may take up to 2 minutes.
Response:
46. Did apply command successfully complete?
If YES, then STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If NO, then call your local RTAC or CTS.
The addressed IMA LAN resets after the software is
installed.
The IMA LAN FAULT LED goes on for the duration of the
reset and goes off after the reset.
The addressed IMA LAN resets after the software is
installed.
The IMA LAN FAULT LED goes on for the duration of the
reset and goes off after the reset.
DDM-2000 OC-3 M
Detailed Level Procedure:
ULTIPLEXER
DLP-528
Page 11 of 12