Lucent DDM-2000 OC-3 User And Service Manual page 31

363-206-285
Issue 3, June 2001
Table A – Numerical List of TOP Procedures (Note)
Detailed Level Procedures (DLP) Tab (Contd)
DLP-532 Install New Software Generic Program
Network Element Software
Local Shelf Download In-Service System
DLP-533 Introduction to the PC
DLP-534 Copy Diskettes and Make Backups
DLP-535 Upgrade BBF2 TGS To BBF2B/BBF2C TGS or BBF4 TG3
DLP-536 Perform Test of RT Batteries Using 197A BATTERY LOAD TEST SET
DLP-537 Check 197A BATTERY LOAD TEST SET
DLP-538 Establish TL1/X.25 Interface
DLP-539 Test ED-8C733-30, G7 Fan Shelf
DLP-540 Replace ED-8C733-30, G4 Fan Filter
DLP-541 Enable or Disable System Security and/or Edit, Delete,
or Enter a User's Login
DLP-542 Replace Existing OLIU With Different Type OLIU
DLP-543 Change Timing Mode on BBF2 TGS, BBF2B/BBF2C TGS or
BBF4 TG3 Circuit Pack
DLP-544 Perform OC-3c (STS-3c) Transmission Test
DLP-545 Unused
DLP-546 Make VT1.5 (DS1) or STS1 (DS3) Cross-Connections
Using CIT Single OC-3 or OC-12 Ring Configuration
DLP-547 DDM-2000 Receiver Sensitivity Test
DLP-548 Replace Defective Fan Pack
DLP-549 Install BBG8/BBG8B SYSCTL
New Shelf Only BBG9 OHCTL Installed
DLP-550 Make VT1.5 (DS1) or STS1 (DS3) Cross-Connections
Using CIT Dual Ring Interworking Configuration
DLP-551 Replace DDM-2000 OC-3 Shelf User Panel
Out of Service
DLP-552 Install/Remove Lightguide Buildout
DLP-553 Perform DS3 Transmission Test Dual Ring Interconnection
DLP-554 Perform DS1 Transmission Test Dual Ring Interconnection
DLP-555 Remove –48 V DC User Panel Fuse
DLP-556 Perform End-to-End OC-1 Optical Line Test
DLP-557 Make VT1.5 (DS1) or STS1 Cross-Connections Using CIT
Single/Dual Homing OC-3/OC-1 or OC-12/OC-1 Ring Configuration
DLP-558 Make VT1.5 (DS1) or STS1 Cross-Connections Using CIT
Stand Alone OC-3/OC-1 Ring Configuration
Operation and Maintenance:
DDM-2000 OC-3 M
*
(Contd)
ULTIPLEXER
IXL-001
Page 15 of 18