Lucent DDM-2000 OC-3 User And Service Manual page 976

DLP-534
: Detailed Level Procedure
Page 2 of 8
There are three steps required to create a working copy:
1. Start MS-DOS software.
2. Format a new diskette(s).
3. Copy the original diskette(s) that you received with your package to the working
diskette(s).
Starting MS-DOS Software
Starting MS-DOS on some PCs may require you to insert your copy of the MS-DOS
diskette into your floppy drive, close the door, and reboot or turn on the PC. The disk
drive indicator light will come on, and the PC may print out diagnostic results on the
monitor. PCs which operate in a Windows
Windows by clicking on the Start button, then Shut Down, then Restart the
computer in MS-DOS mode. In Windows 3.1 , exit windows using the File menu to
operate your PC in MS-DOS mode. When MS-DOS software is ready, a prompt (for
example, A>) appears on the display screen. This is how MS-DOS software lets you
know it is ready for you to type a command.
Formatting a New Diskette
You will need a blank diskette(s). It is a good practice to label diskettes so that you
can keep track of them. You should prepare a label for the diskette(s) marked as
DDM-2000 OC-3 Release a.b.c - working copy. The a.b.c is the release version that
you are copying.
!
WARNING:
Do not write on diskette label using a ballpoint pen or pencil.
When the prompt A> appears, type the following command, and then press <Enter>.
(If you make a mistake while entering this command, you can press the Backspace
key, or equivalent, which will erase one character at a time.)
You will see a message similar to the following (the exact wording of the message
may vary depending on which PC you are using):
Now open the drive door and remove the MS-DOS diskette. Place the MS-DOS
diskette in its envelope, and set it aside for the time being.
† Windows is a registered trademerk of Microsoft Corporation.
format a:/s <Enter>
Insert new diskette for drive A:
and strike any key when ready
DDM-2000 OC-3 M
Issue 2, February 2000
†
95 environment require you to exit
ULTIPLEXER
363-206-285