Lucent DDM-2000 OC-3 User And Service Manual page 760

363-206-285
Issue 2, February 2000
5. NOTE:
If the response is not correct in the following procedures, replace the
BBG6 STS1E circuit pack.
Seat a BBG6 STS1E circuit pack in FUNCTION UNITS group slot A-1, B-1, or
C-1.
Response:
6. If required, seat a second (protection) BBG6 STS1E circuit pack in
FUNCTION UNITS group slot A-2(P), B-2(P), or C-2(P) of the same
FUNCTION UNITS group.
Response:
7. Repeat this procedure from Step 1 for each pair of BBG6 STS1E circuit packs
to be installed.
8. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
Figure 1 – BBG6 STS1E Option Settings
FAULT LED on the STS1E lights for about 20 seconds
then goes off. ACTIVE LED lights on the first BBG6
STS1E circuit pack of the pair installed.
FAULT LED on the STS1E lights for about 20 seconds
then goes off. ACTIVE LED remains off.
DDM-2000 OC-3 M
Detailed Level Procedure:
ULTIPLEXER
DLP-502
Page 2 of 2